Tyre Retreading Machine

Tyre Retreading Machine

Production Process

1, initial examination

a, the wire can not be broken at the rim, the appearance should be intact

b, there must not be too many scars on the sidewall, and it can not be broken

c,The depth of local wear cannot exceed three layers, the radial tire cannot break the steel wire, the steel wire is drawn, and there must be no rust marks

2,Drying

Carefully clean and dry to remove moisture

3.buffing

The tyre is first polished on the buffing machine for rough grinding, and the waste rubber on the surface is removed. According to a certain arc, the depth of the sand is shaped. the small grinder is used to manually repair the hole and scars.

4, building

Put the latex rubber on the top surface of the tire, and put the same rubber on the precured tread.After fully drying, put it on the building machine

  1. Installation of tire parts

Put the tires on the envelop and rim loader for packaging the outerwear of the tire, and then use rim loader to clamp the specially made rim to coat etc.

  1. curing

Put the prepared tire in a curing chamber

7, product inspection

Inspect all retread tyres to make sure the quality.